Hi,

please...

- open the attached odg
- select the green line
- change its color (you can use the toolbar therefor)

Bug 1:
Note that the position is changed (space to the rectangles is decreased)

- close the odg (without saving) and reload it
- select the green line

Bug 2:
Note that the small red dot where such lines can be moved is missing on the
right (vertical) part of the line.

Bug 3:
Move the mouse over small red dot on the lower (horizontal) part of the green
line. The mouse pointer has horizontal instead of an vertical moving style.

Bug 4:
Try to drag the line by the red dot (of Bug3). It only can be moved near to the
rectangles (like the position it gets in Bug 1).


This bug is much more major than it may appear while reproducing these steps! I
found it while editing an a bit more complex drawing containing some connector
lines. If I select the whole drawing to change colour of all lines, connector
lines suddenly change position which destroys the drawing.

Sometimes connector lines can only be selected by clicking on there beginnings
or ends. But it's difficult to write easy to reproduce steps therefore.